Voice Elements SIP Platform (formerly HMP Elements) - Configure with AudioCodes Gateway
m (moved HMP Elements - Configure with AudioCodes Gateway to Voice Elements SIP Platform (formerly HMP Elements) - Configure with AudioCodes Gateway)
|Line 1:||Line 1:|
<seo title="Voice Elements
<seo title="Voice Elements" metakeywords="SIP Platform, ,IVR" metadescription="Elementsto ." />
If you would like to use all of the functionality in
If you would like to use all of the functionality in Elements , but still need to use TDM equipment, we recommend using AudioCodes devices.
Revision as of 03:47, 23 April 2013
If you would like to use all of the functionality in Voice Elements Platform, but still need to use TDM equipment, we recommend using AudioCodes devices.
One of the hardest parts of the setup is to get the gateway on the network. You will want to make sure that you follow the instructions in the AudioCodes documentation. Once you have done this. If you will be traversing a router to make calls, you will need to define the appropriate settings in the VoIP > SIP Definitions > General Parameters Page.
If you need to configure the gateway to use STUN, you can find the appropriate settings in the System > Application Settings Configuration Page.
Lastly, you will need to tell the gateway where to send calls to. This setting is in the VoIP > GW and IP to IP > Routing > Tel to IP Routing page:
Notice, how you can define, which phone numbers should get sent to which IP addresses. In this case we have configured the wildcard (*) to send calls to the IP address starting with 74. Because we are using a wildcard, we will send all calls to that IP address.
Settings to use for a PBX
By default, AudioCodes MP devices (114 / 118), are configured to be connected to regular analog telephone lines. Under the default settings, when you connect these devices to a PBX, you may have trouble getting the AudioCodes device to recognize when a call has dropped. There are a few common settings that you will want to set to make sure that the AudioCodes device recognizes hangups with a PBX:
1) Make sure the "Full" (towards the top) radio button is checked, and expand Voip > GW and IP to IP > Analog Gateway > FXO Settings, and check the following fields:
Make sure Disconnect on Dial tone is set to "Enable" Make sure Disconnect Call on Busy Tone Detection "Enable"
2) Go To Voip > Coders and Profiles > Tel Profile Settings
Make sure Enable Polarity Reveral is set to "Enable" Make sure Enable Current Disconnect is set to "Enable"